Scrappy Hunter’s Star Tutorial (a layer cake friendly pattern)


scrappyhuntersstarquilt

Early this week I shared photos of my scrappy version of a Hunter’s Star quilt .  I realized when I was finished with it that I had stumbled on a great pattern for a layer cake, so I thought I’d share a quick tutorial.

hunterstarwithdots

Fabric requirements:

Each 8 pointed star in a hunter’s star quilt is made up of four smaller blocks.  For the quilt I made, which is 64 inches square, I used:

32 – 10 inch squares of various fabric prints (which is most of  a layer cake, although I cut my own squares from Bonnie Christine’s Reminisce collection for Art Gallery Fabrics) 32 – 10 inch squares of background fabric (2.5 yards of fabric.  I used a black on white swiss dot print for my background) Note:  If you’re using a layer cake, you should have 40 prints to choose from.  I recommend eliminating those prints that most closely match your background fabric so they don’t get lost in the quilt and make it more difficult to see the pattern.  For example, if you’re using a solid white background and the layer cake has a solid white print in it, or a white print with a very light pattern on it, you may want to skip it.  That said, you can see in the photo above that I did use some low volume prints from the collection in my quilt top.  I liked using a few of them, but there were other prints that were even softer which I set aside and didn’t use in this project.   Also, because I used a swiss dot print for my background, the softer prints I included still looked different from the background fabric.

If you want to increase or decrease the size of the quilt, know that one print and one background square will make two blocks.  Four blocks will give you a full star in the center of the blocks.

teninchsquares

To make the blocks, we’ll be cutting triangles, diamonds and trapezoids from each 10″ square.  To begin, cut your square in half diagonally:

step1

Place the two triangles on top of one another for faster cutting.  With a ruler, measure 2.5 inches from the edge of the diagonal cut, as seen below with the small ruler.  Notice that on the bottom left and top right edges of the triangle my cutting ruler is more than 2.5 inches from the point of the triangle.  The measurement that matters is the one from the diagonal edge we just cut.

step2

Cut along that line, creating two smaller triangles and two trapezoids.

step3

Set aside the triangles and line the trapezoid strip up carefully on your cutting mat.  I prefer to use my 45 degree angle lines and I line the far right edge up on an inch line.  From that far right side, measure into your trapezoid 2.5 inches once more.

step4

Cut your fabric, creating two diamonds.  Repeat once more, measuring another 2.5 inches from the cut you just made and cutting two more diamonds.

step5

From one ten inch square you should now have two triangles, four diamonds and two trapezoids.

threeshapes

Repeat this process with the remaining prints.

cutallpieces

Now do the same thing with all the ten inch background squares.  Every piece in this quilt is cut the same way.

repeatwithbackgroundsquares

Once all the shapes are cut you can put together a block.  Think of each block as having two triangles.  One uses background fabric for the diamonds and prints for the triangle and trapezoid, and the other triangle uses background fabric for the trapezoid and triangle and the diamonds are prints.  Below is the layout for a hunter’s star block:

huntersstarblocklayout

Sew the diamonds first.  Carefully turn a printed diamond piece right side down and carefully line it up with the right side of a short end of the background trapezoid.  Because we are sewing angles, do not line the pieces up from corner to corner.  Instead you will need to have a tiny (1/4 inch) triangle sticking out on each end.  This will allow your fabrics to line up straight after you sew them together.

sewdiamondtotrapezoid

Here’s a closer look at how to line them up.  Sew the pieces together using a 1/4 inch seam allowance.

lineupseam

Do the same thing with the diamond at the other end of the trapezoid.

addseconddiamond

Press the seams open.  *In this quilt I pressed every seam toward my printed fabrics so the seams would nest when pieced together.

pressopen

Now repeat the process, sewing the background diamond pieces to the printed trapezoid piece, again ironing the seams toward the print.

repeatwithotherside

Next, sew the triangles to the trapezoids.  Once more, you will have the corners of the triangles hanging over the edges of the trapezoid piece.   On this seam the overhang will likely be more than 1/4 inch, which is fine.  Just try to center the triangle as best you can with equal overhang on each side.  sew together.

addtriangles

Repeat with the other half of the block.  Note:  At this point, I ironed the seams toward all the printed fabric triangles, and on the other triangle I ironed my seams toward the printed fabric diamonds.  If you do this, your seams will nest when piecing together your quilt top.

bothsidesdone

And finally, sew the two triangles together.  The most important thing is getting the seams between the diamonds and trapezoids to nest together (see where my pins are).

sewsidestogether

Once again, press the final seam toward the printed fabric diamonds.  Your block is finished!  Once you have the hang of the block, chain piecing them together is very fast and efficient.  I chain pieced a diamond to one end of every trapezoid, then did the same thing with the other end.  Finally I chain pieced all the triangles on and then sewed the blocks together.  It really is a very fast finish.

scrappyhuntersstarquiltblock

Trim each block carefully to 8.5 inches square and you’re done with the block!

trimblock

When you’ve pieced your first four blocks together you will see the 8 pointed star that emerges in the corners of the blocks.  This really is such a beautiful block.

huntersstarquiltblocks

Lay out your blocks in 8 rows that are 8 blocks long (each block making 1/4 of an 8 pointed star) and sew them together, paying careful attention to matching the seams on the diagonal points and in the corners.  Sew the rows together and you have a finished quilt top!  I really love the scrappy look of this quilt, as it freshens and updates the traditional hunter’s star block in a beautiful way.  If you want to see what a quilt would look like in just two colors, you can see my traditional red and white Hunter’s Star quilt here .  You can also find pictures of a Hunter’s star made with solid linen and a single print in my Hunter’s Star pillow here .  There are so many different ways to interpret this quilt block.  I hope you have fun!

scrappyhuntersstar1

Jennifer

Reminisce: Scrappy Hunter’s Star Quilt Top


scrappyhunterstarblocks

Phew!  It seems like I haven’t finished much this year in the quilting category but I have a finished quilt top!  This one makes me happy and I hope you’ll indulge a bit of rambling as I share the reasons why.  Back in 2011 I finished a traditional Hunter’s Star quilt , red and white, which has been snuggled in, spilled on, stained and loved and then used some more.

huter's star quilt close

I love this quilt, largely for it’s bold design but also because we’ve loved it so much.  Interestingly, I also get new comments on that blog post all the time, and as I was pondering that a few months ago I suddenly saw the design with new eyes.  I pictured a scrappy, colorful version, larger than my original quilt and with a small print instead of a solid for the contrasting background.

reminiscefabric


Bonnie Christine’s
first fabric collection, Reminisce, was the perfect fit.  I love the fabrics in this line.  I sketched, calculated and began to cut, but other pressures with the holiday season came along and I set it aside.  I was pulling it out to start sewing in February when I had the opportunity to participate in the Sweet as Honey Blog Tour for Bonnie’s new Sweet as Honey collection.   My first idea for the blog tour was a Hunter’s Star pillow,  which I made by adjusting my measurements yet again and using a natural linen with the fabric she sent me.  I especially loved how the hand quilting turned out:

huntersstarpillow

As you can read in my post, looking at those little beehives generated another idea with Bonnie’s fabric which came to life in my Hexagon Beehive Mini Quilt:

hexibeehiveminiquilt2

When the blog tour was over, I returned to my idea of a scrappy Hunter’s star quilt and got to work.  Here is my finished quilt top:


**edited to add:  Because this quilt top uses 10 inch sqaures and is perfect for a layer cake, I decided to post a tutorial.

You can find it here.


scrappyhuntersstar1

The eight pointed star pattern doesn’t emerge as readily in this version, but still I love it.  I love the tiny black polka dots, love the colors and patterns, loved hanging it from my cherry tree that’s suddenly covered in blossoms.

scrappyhunterstar

This quilt top also reminds me of a beautiful principle taught by Twyla Tharp in her book, The Creative Habit. I read it a few years ago and one of the parts I loved most was the chapter about scratching for ideas.  What stuck with me was her discussion of big and small ideas.  She writes about big ideas as things that often come to us when we’re wanting to catch people’s attention, make lots of money, or make a name for ourselves.  They are often difficult to execute and can become all-consuming.  On the other hand, small ideas may be less significant but are often things that keep generating more ideas.  They feed creativity.  Sometimes the small ideas end up being best.   I guess the biggest reason this quilt top makes me happy is because for me, it’s a celebration of small ideas.  I get ideas all the time and some are better than others.  Some of them take shape and others seem to fight me.  Some of  them I don’t have time for while others send me down an unexpected path.  This little idea of re-thinking my picture of a hunter’s star quilt block has been a small idea that generated more ideas, more opportunities, and especially more joy in creating.  I’m sure someone, somewhere, has already done this with this block, but I’ve never seen it.  I certainly didn’t create the hunter’s star quilt block, but I’ve loved following the trail of my own vision, bringing to life something I have only seen in my mind’s eye.  This is something we quilters do all the time, interpreting patterns with our own colors, variations and twists.  It’s one of the things I love most about the quilting community – watching how we all inspire each other and are in turn inspired, with more creative outcomes than we can count.  Little ideas generate beautiful things, and the more we do it the easier the process becomes.

scrappyhuntersstar2

When I look at this quilt top, I see a physical reminder of the journey of creativity that comes through small ideas.  That journey brings me joy and is an experience I hope will always be part of my life in some way or another.

I hope it’s part of yours, too.
Thanks for visiting!
Jennifer Linking to Freshly Pieced!

Sweet as Honey – Hunter’s Star Pillow & Hexagon Beehive Mini Quilt


blog-tour-image

Welcome to Day One of the Sweet as Honey Blog Tour!
I’m honored to start things off by sharing my projects made with Bonnie’s lovely new fabric collection, Sweet as Honey.
I loved her first fabric collection, Reminisce, and was waiting eagerly for Sweet as Honey to arrive.  It does not disappoint!

sweetashoneystack

This collection has captured my heart with its beehives, hexagons, and nestled deer.  I’ve been drawn to the warm yellow, coral and orange tones in this line.  They remind me of a sunrise – my favorite part of the day.  When the light hits these fabrics just right, they seem to glow.  The warmth and color make me smile.

sweetashoneypackage

Bonnie generously sent me this beautiful little package to play with, which I immediately paired with a natural linen to create a Hunter’s Star pillow.

huntersstarpillow

I hand quilted the pillow front with perle cotton to emphasize and frame the eight pointed star.

handquilting

I used a coral solid for the pillow back and chose to bind it with a low volume print for added contrast.

pillowbinding&back

The textures, colors and design harmonize well together and the pillow has quickly become a favorite.  It’s a cheerful sight on all the rainy, overcast days we’re having lately.

huntersstarpillow2

While I was planning this pillow, another idea came to mind and I couldn’t resist trying it.   I enjoy growing lavender on our property and every summer I marvel at the wonder of dozens of honey bees surrounding me as I harvest.  The Sweet as Honey fabrics reminded me of that feeling and fueled the endeavor.

hexagonbeehiveminiquilt1

In my first effort at English paper piecing, I made 125 half inch hexagons, pieced together in a scrappy style to create a Sweet as Honey beehive!

hexibeehivemini3

Once again, I preferred linen as a background and added the hexagon print from Bonnie’s line for a binding.  This mini quilt measures 15″ by 16″ and also features a single honey bee, embroidered in white, in the corner.

miniquiltback

It seemed only appropriate to use the peach honey house print on the back!:)

perlecotton

I wanted to add dimension to the beehive, so a variety of coordinating perle cottons were used to hand quilt around each hexagon.  This step took time, but was completely worth it.  I love the shine of the threads mingling with the colors and prints of the hexagons!

handquiltedbeehive

I’ve been watching the growing mini quilt craze with interest, and this is my first mini.  It already hangs in my sewing room, a bright reminder that Spring is on it’s way.

hexibeehiveminiquilt2

Thanks so much for visiting, and many thanks to Bonnie for creating such lovely fabrics and for allowing me to participate in the Sweet as Honey Blog Tour !  Be sure to keep up with the tour, as there are many talented people creating beautiful things with Sweet as Honey .  Tomorrow’s feature will be Jessica at Haile & Co .  Make sure you visit and see what she’s made!

Best Wishes, Jennifer

1 2 3 4 13